11 August 2013

Easy Ways to Fix Computer Motherboard

The motherboard or mainboard is the board/main board where the components such as the microprocessor and the main memory (RAM, ROM, BIOS) chip along with other controllers. There is also SLOT Expansion is a place to put the cards additional functions to improve the facilities and the skills needed. Microprocessor mounted on sockets/slots corresponding to the shape and size of the microprocessor, such as socket 370, 470, socket LGA 775, socket A 462 (AMD), socket slot I (Pentium 2 and 3).

On the motherboard, microprocessor communicates with other components via a bus or data path. This bus has evolved from bus 66, 100, 133, 200, 266, 333, 400, 500, 800 MHz. This development work to compensate for the faster microprocessor. Expansion slots are also experiencing growth. Chart table has been included on the motherboard usually when you buy a CPU/Mainboard.

Easy Ways to Fix Computer Motherboard


Easy Ways to Fix Computer Motherboard

Total dead
Check the power supply: In the state of the power cable from the power supply off, disconnect the cable socket mounted on Mainboard ATX1. Once detached, attach the power cable, connect the green cable with black cable, check that the power supply fan spinning? If the spin is a good power supply. Back off the extension cord and plug it back earlier ATX1 cable to the motherboard. Check the Clear CMOS Jumper, whether in position or Free Clear, usually when a new motherboard, CMOS jumper position in the Clear position. Check the IC Chipset in connected and in the Switch On, whether or not excessive heat, over-heat means the chipset is already damaged. For CMOS IC part so far are not sold freely.

Also check that the switch on its functioning.
Motherboard dismantle it carefully, try to wear clean thinners, if you can not use thinners bottle is in the can. After you dry clean. Replace the IC regulator which is located around the ATX power socket on the motherboard. Replace the capacity Elco 1000 up to 3300 uf/10 volt which is located around the ATX power socket on the motherboard. Carefully assembling the components to make sure the power cord is not connected to electricity.

Flash But Not Shown
Try to look and listen if there is sound or beep sound. If there is, there is usually damage the processor, memory, and VGA. Check Processor, you try to hold the coolant if excess heat or cold? If it means overheating processor fan is not working properly then you will change, but if it means the processor cooler is not working aka broken. Check the memory, if memory is usually broken voice on the speaker beep 3 times. Are turned off, pull the pin clean memory using a pencil eraser to clean, then reinstall. If it's still broken means no one IC is broken. Check the VGA card, unplug the VGA card, in case of death/off you try to press, there is less possibility of entry or try to wash the feet/her pin. If the VGA card using a fan, clean the fan. If it still does not appear you try to check maybe the monitor is not a flame, to make sure that broken monitor or CPU, try to press keys on the keyboard Numlock, whether NumLock light a flame or not. If the flame is damage to the CPU.

Is the standard when repairing my computer, I always clean out the dust, whether it's the motherboard, memory, cdrom, floppy disk, etc., because it is so what else could affect computer in a dirty/old is not cleaned. But you have to be careful in the process and do not rush.

Hang And Often Off/Restart (Reset) Self
Check the Power Supply, try another power supply if it still restarts itself or hang. If after the power supply was replaced normal/good, power supply means there is a problem. Replace it if it can be fixed I myself was not sure whether it is still able to function properly, because the power supply is a vital component. Especially for the price is very cheap power supply, I suggest changing it. Check if there is virus, anti-virus programs should always be installed and enable auto protect. I used to use Norton Anti-virus. You should frequently update your antivirus because if there is a new variant virus, your anti-virus will detect and eliminate the virus. When the computer hangs and no blue screen messages like "vxd error at address ...", there is usually a problem in memory. Clean the memory as the above step.

Try to reinstall Windows.
If it still hangs/restarts itself trying to check on the motherboard, you notice physical changes in the components especially elco/capacitor, a black round no writing in capacity between 1000 uf/10Volt up to 3300 uf/10 volts, usually seen, if the damaged looks bloated/swollen and leak or rust.

CMOS Checksum Failure (Battery Low)
Symptoms and solution:
CMOS failure message (damage to the CMOS battery, replace battery) Setting the date, time and other configuration in the BIOS to change (After replacing the battery, do the settings in the BIOS).

0 comments:

Post a Comment